Turns out I was just being stupid, marking dimensions on the back rather than front as it clearly shows on page 38, so its the shorter corner of the mitre cut that is lined up.
Next question... The book says noting the position of the diagonal braces in relation to the other rails. but I'm not sure about D1 and D2 where they fit to U1 and U2 as having them flush with outer frame doesn't look like it has much contact.
I have a picture so you guys can check it but will have to do that later as not at computer.
Last edited by Shorty : 16th October 2012 at 08:33 PM.
Reason: Edited as the book does not say line up with outside
|