Thread: Need a couple of chassis dimensions pls
View Single Post
  #4  
Old 3rd November 2012, 02:05 PM
The V8 Files The V8 Files is offline
Senior Member
  
Join Date: Jul 2011
Location: Biggleswade, Bedfordshire
Posts: 346
Default Oops! This is tighter than I thought :(
Right, a little demoralised, I new this was going to be a tight fit but its worse that I thought:

Front Right Sump and Alt pulley fouling.








Not sure about total height and width, I remember seeing somewhere recently a drawing showing bodywork clearances so will have to do some searching and research and then consider all my options.

Just found the diagram:

http://www.haynes.co.uk/forums/attac...7&d=1265401544

I'm off to do some measuring up.
Last edited by The V8 Files : 3rd November 2012 at 02:24 PM.
Reply With Quote