[K4KEV]

After much trolling the internet and ebay last week for a tight radius rolled tip stainless exhaust end and not finding anything remotely suitable, I do what I usually do and make my own....now in doing that it means I can be different as usual. So here is a quick run down of how I made it.
First raid the scrap bin for a piece of 2" stainless exhaust pipe, then give the bit I'm using a polish up and scrape the carbon out from inside, then I give the piece a 45 degree cut then mark out the next angled cut to intersect the first one, now grabbed the first offcut and gave it a bash or two to flatten the steel, now using the 45 degree angle as a template mark out on the flat piece of steel. Now attack with angry grinder until correct shape, when that has I nice fit its back onto the tig table and weld it onto the exhaust tip grind back then polish up with a powerfile ......now to achieve the "rolled tip" I silver soldered a length of shaped brake pipe onto the exhaust exit, the following pictures will make sense of what I have just described.