Yeah TT I have found out the hard way.....measured and drilled holes to suit nosecone to chassis sitting flush.....so those holes will be getting elongated to suit chassis WITH side panels fitted. Also found out the side panels would not fit very well where the chassis has the cranked angle is at the floor sector ....this was down to the 3mm ally floor I am using, just too thick, so I have had to cut away a section of side panel where it goes around and up to the floor then use rivets on the side to pull it onto the chassis.....not ideal but has done the job.
Both side panels now fitted and will be moving onto the rear panel which be removable due to the tank.
