After re-appraising my exhaust, I have decided to "make sure" of a pass on iva criteria......mainly the edges so I have used a technique I have used before.
For the muffler ends I took some 6mm brake pipe and bent it to the exact diameter, then I took my b&d powerfile (you could use a flap disc) and began to grind the pipe back to just before the inside of the pipe .....I just used a knife to break through the rest, then it was a case of tweaking it to the same thickness of the muffler ends so it will fit over them and produce a "rolled tip" effect.....gonna solder them up today
