Quote:
Originally Posted by ayjay
Get your seats
fix the runners
Fix flat bar across runners
place in position
tack weld flat bar to chassis shielding seat from spatter(  so you dont get mini burn holes in your seat )
remove seat and runner then fully weld
QED |
My advice - have the flat bar over length by a couple of inches either side - clamp it up against the bottom of the chassis (i.e. - where the floor will go) then you can play about shifting it nearer to / further way from the transmission tunnel - if required. I certainly had to tweak my seat side-to-side - so actually laid it all up on a piece of chipboard clamped to the bottom of the chassis - and marked it all up before cutting the flat bar.... That also meant I could remove the seat fully to keep it safe from spatter before welding.