Just wrapped up this weeks work. Got the drivers side skinned and wrapped. Prior to riveting in the drivers panel, I went ahead and added the brake bias adjuster I forgot to install weeks back. Thankfully this task was much easier than expected.
Once that was done, I decided to finish up trimming the interior. I had already wrapped the center with suede, so to finish off the look on the outside I got some trim from mcmaster
http://www.mcmaster.com/#8124a37/=r7leks then wrapped that in suede and riveted it to the frame rails. This gives me a armrest on the outside of the frame as well as concealing the cut edge of the metal. I am super pleased with how this turned out. I'm going to need to get some suede water protector, in the off chance I even get caught in the rain.
On a down note, I think my injectors are gummed up. Engine appears to only be running on 2 or 3 cylinders. Thought the fuel filter had gotten clogged after test driving it last week, but it must have been the injectors as the car will not run without the throttle opened.