|
|
#1
9th September 2010, 07:33 PM
|
||||
|
||||
Behind seat pannel cut out
can anyone help?
I'm doing the templates for the car and am about to start drawing but then noticed there is no hight for the cut out, it gives the width but no height  
|
|
#2
9th September 2010, 08:11 PM
|
||||
|
||||
|
Tape measure? Ruler?
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding.
|
|
#4
9th September 2010, 08:32 PM
|
||||
|
||||
|
the plan for the template of the seat back panel is on page 97, top sketch, overall height is 570mm, but be aware of the two bend lines, tho the sketch does show the position/dimensions of the required bend lines to facilitate the 17degree lean back of the seat back area.
Hope this helps. cheers andy
|
|
#6
9th September 2010, 08:50 PM
|
||||
|
||||
|
Quote:
 The height of the tranny tunnel side panel, if thats what you need is 302mm at the rear ( thats fitted upto the seat back panel end) & the gear stick end is 345mm on drivers side & 352mm on passenger side................. OR If you look at the diagram on page 45 , lower sketch it shows the height from the base of the bottom chassis rail to the top of the tranny tunnel rail TT7 as 305mm perpendicular height. hope this helps  cheers andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
