rear upright jig issue!

[onedayTM]

Hi guys,
It may well be me but just had some new parts made ( RU2 ) as previous ones were not correct. Have made jig to book spec and also template for positioning bush for hole alignment. when in jig RU2 sits about 3mm taller than 65mm height of 5inch tube and measurement 66mm hole centre to base plate of jig is also out, fig 5.24 page 70. Was there a correction to template when height of 5inch tube altered from 70 to 65mm ?
Has anybody else checked dimensions when making there uprights. Have tried to include pic but cannot get it downlodedfrom computer as it tells me file is too big. Its on photobucket if you dont mined looking.
cheers
tony.http://s680.photobucket.com/albums/vv162/tm54