|
|
|
|
#1
1st September 2016, 07:15 PM
|
|||
|
|||
Roll cage bender, help required!
Hello all
Been a while since I have been on and work on car has been slow. I am after some help. I have bought some 2"CDS to make a MSA spec cage. Problem is my tube bender is ok with thick wall steel but just creases this stuff. I know that people say to fill with sand etc but not sure how successful that will be and this stuff is bloody expensive to keep ballsing it up! I don't really want to fork out for a mandrel bender either. Does anyone have a mandrel bender or know anybody how might bend it for me? I am in North Wales. Thanks Leroybrown 
__________________
My Blog : leroysroadster.wordpress.com 
|
|
#2
7th September 2016, 09:15 AM
|
|||
|
|||
|
You need a bender with former and guide like the H3 hilmor, you are welcome to borrow it.
Mine is the same as the one below but has been converted to electric/hydraulic. 
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 Last edited by robo : 7th September 2016 at 10:50 AM.
|
|
#3
7th September 2016, 03:03 PM
|
|||
|
|||
|
Hi mate, I think I know someone that can do it for you down in Holt, they do agricultural work but can do some serious shit work, give me a bell next week, as i'm crazy busy right now, and we can sort something out, it will be easier to take you there rather than try to direct you.
Arfon
|
|
#4
8th September 2016, 09:28 AM
|
|||
|
|||
|
Hi mate I have sent you my number in a pm
Arfon
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
