|
|
|
|
#1
10th March 2016, 11:59 PM
|
||||
|
||||
Side panel lower lip
Hi all
I'm considering doing away with the lower lip on my ali side panels and instead riveting them to the sides of BR 3,4,5,6. My reasoning for this is that my floor is already attached to the underside of these rails with sealant and rivets - I don't like the idea of going through that lot with another load of sealant/rivets. My worry is that the resultant sharp edge would fall foul of the IVA 2.5mm radius rule. Does anyone know if this would be the case? Thanks Josh 
|
|
#2
11th March 2016, 09:24 AM
|
|||
|
|||
|
Leave enough on the panel and tap over the edge to fold onto floor and silicone it .
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
