|
|
|
|
#2
26th February 2012, 05:45 PM
|
||||
|
||||
It needs edge trimming, and the passenger side will need boxing in for iva.
__________________
A few build photos... www.photobucket.com/ntsengineering 
|
|
#3
27th February 2012, 10:49 AM
|
||||
|
||||
|
I was unsure about the bottom edge of the dash so I extended it into a full 180 degree radius. Also the center section of the dash did not meet with the top of the transmission tunnel so I extended that at the same time.
Boxing in the underside of the passenger side is not necessary for IVA. Gus didn't on his. All they made him do was add a piece of rubber U-trim to the return lip on the scuttle as it overhung the top rail.
__________________
http://s831.photobucket.com/user/dav...ter%20Pictures OTR 01/05/14 - 1.6 CVH, Type 9, Bike Carbs, Megajolt
|
|
#4
27th February 2012, 08:02 PM
|
||||
|
||||
|
depends, if there is wiring under there
__________________
A few build photos... www.photobucket.com/ntsengineering
|
|
#5
27th February 2012, 08:34 PM
|
||||
|
||||
|
Gus did have wiring but it was neatly wrapped so not likely to get caught by a passenger
__________________
http://s831.photobucket.com/user/dav...ter%20Pictures OTR 01/05/14 - 1.6 CVH, Type 9, Bike Carbs, Megajolt
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
