|
|
|
|
#1
1st September 2012, 10:11 AM
|
||||
|
||||
New body parts
We have now added the aero screen, dash and boot to our collection here is a link
"http://www.equinoxproducts.co.uk/shop/viewcategory.php?groupid=18" We have been asked to make a nose like the Saturn one but with an oil cooler intake at the bottom, the pattern should be ready for a picture at the end of next week so keep an eye out for it. I would like your feedback before it goes under a mould. 
|
|
#2
1st September 2012, 10:36 AM
|
|||
|
|||
|
We have been asked to make a nose like the Saturn one but with
an oil cooler intake at the bottom, the pattern should be ready for a picture at the end of next week so keep an eye out for it. I would like your feedback before it goes under a mould.[/quote] Have no fear you will get some constructive criticism on here  I am impressed with the progress you have made on the rest of it. I like the rear tub with the lid and dash panel. Its all a time saver when it comes to finishing off the car. I will also be looking for some slightly extended rear arches to cover some fat rear rubber, I am not alone on this one either so it may be worth you looking at this in the future. Keep up the good work.Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669 Last edited by robo : 1st September 2012 at 10:47 AM.
|
|
#3
1st September 2012, 10:39 AM
|
|||
|
|||
|
One body to fit Haynes like the race car please !
 Is there no way it can be made to fit ?
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
10th September 2012, 09:15 AM
|
||||
|
||||
|
Lhd
The pattern is made for the LHD just need to make the mould.
|
|
#6
10th September 2012, 09:55 AM
|
|||
|
|||
|
Impressive
I am impressed with your progress because you are nose to the grindstone and getting on with it. Not easy to develop new products and earn the sheckles at the same time. Next time I am down you way is it ok to pop in and have a nose? Seeing is believing Bob
__________________
When The Results Disagree With The Theory: Believe The Results And Invent A New Theory If I had two brains I,d still be a halfwit The cave http://s1116.photobucket.com/user/my...deshow/mancave The build http://www.haynes.co.uk/forums/showthread.php?t=12669
|
|
#7
10th September 2012, 08:48 PM
|
||||
|
||||
|
Quote:
|
|
#8
11th September 2012, 01:56 PM
|
||||
|
||||
|
Quote:
|
|
#10
10th September 2012, 08:44 PM
|
||||
|
||||
|
Quote:
I asked this again today to be sure. It will fit over the top chassis rail if its there. Its been designed to fit the chassis 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
