|
|
|
|
#1
17th July 2017, 10:01 AM
|
|||
|
|||
Pedal bushes
Has anyone got tips on where to get the bushes, crush tube and the 'outer' tube for the book spec pedals from? Or some appropriate alternatives?
Most tubing I see for sale is in lengths rather longer than I would want given the brake, clutch and accelerator pedals must only use about 80mm in total...!
__________________
http://meandthekitcar.wordpress.com/ 
|
|
#2
17th July 2017, 10:15 AM
|
|||
|
|||
|
I may have a spare set I never used. If you can hold on till tomorrow i can check in the garage. Cover postage and you can have them if they are the right bits
|
|
#3
17th July 2017, 11:31 AM
|
|||
|
|||
|
Quote:
__________________
http://meandthekitcar.wordpress.com/
|
|
#4
20th July 2017, 12:21 PM
|
|||
|
|||
|
Can you pm me your email address and I will send over some pics.
|
|
#5
23rd July 2017, 01:24 PM
|
||||
|
||||
|
If you have done the rear part of your chassis as in the book, with the 2 round tubes RP1 and RP2, you should have 19mm round tube leftovers. I used these to make the bush-tubes of my pedals.
Then I carved the bushes in a Teflon rod (would have been better to turn them with a lathe, but I had no possibilities to do so) See beginning of this post on my blog.
__________________
Sylvain Pictures of my completed Roadster https://www.flickr.com/photos/994983...7646799525542/ Build blog: http://vouchtroadster.blogspot.se/ https://cafrazx550.blogspot.com/
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
