chassis metal

[james83mills]

as you may have noticed i'm being cheap when comes to my build, so far it has cost me a grand total of £30 quid and that was for some of the wood to build my chassis on. i've managed to get everything else for free, and that includes the metal for my chassis, the 25 x 25 is fine but i've just checked what i thought was the 19 x 19 but it is in fact 20 x 20 will this make much difference to the build. i know that i will need to adjust the build by a couple millimetres can anyone else think of any other problems

[gus]

Shouldn't make any difference as it is only used for braces & tranny tunnel.

Wouldn't have thought you'd even notice any dimensional differences.

Mark

[geeman]

hi, this has been discussed before and i think people came to the conclusion that its fine to use 20mm as sometimes metal retailer may advertise some boxsection as 3/4in(but you will actually get 20mm) as i think 20mm is more readily found than 19mm. I for one am using 20mm as well and so have others i think, so there shouldt be a problem.

It's fine.

Cheers

Chris

[james83mills]

thanks everyone

[HandyAndy]

by the sounds of it, you,ll be beating me for cheapness of build

seriously tho, best wishes for your build

andy

[chriseyj]

I am sure my 19mm is actually 20mm and it worked fine.

I got quite a bit of my 25mm from some old computer trolleys some schools I work at were throwing out. The teachers were laughing at me sawing them up in a skip in the school car park, felt a bit skanky scavenging desks but at least its recycling.

Saved me a bit of money but still had to buy the longer lengths.