![]() |
|
#1
|
|||
|
|||
![]() I have been doing my rear strut tops /roll bar mounting spent ages marking out for shock brackets then tacking the M8 Nuts and brackets...admiring all my nice work ...then fully welding the lot up and welding it to the chassis...all very good so had a wee fag and a cuppa....and aaaa ya nob i had used wishbone brackets !!!! tools out of the pram ...thats even after writing a note on my book saying SHOCK BRACKETS !!!
|
#2
|
||||
|
||||
![]() Just use packers to correct your little mishap. It could be worse you could have fully welded shock/damper brackets to the chassis tubing in the wrong place.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 |
#3
|
|||
|
|||
![]() Doh!
![]() As already said it will be fine to use packing, where the other end of the damper attaches to the upright needs packing anyway You could get some proper ones turned on a lathe or just use appropriate sized washers |
#4
|
|||
|
|||
![]() To late ...some delicate grinding and a 1mm slitting disc and the diddy bracket off... replaced with the proper one....now i need a single wishbone bracket !!
|
#5
|
||||
|
||||
![]() ![]() ![]() Glad you noticed it so quickly & got it sorted, I can send you a replacement bracket if you wish Andy? just let me know ![]() cheers andy |
#6
|
||||
|
||||
![]() I know that pain only too well
![]() |
#7
|
|||
|
|||
![]() That would be great Andy if you could pm me cost and pand p i will square you up with your prefered payment method
|
![]() |
Thread Tools | |
Display Modes | |
|
|