Engine Number

[Tatey]

Im trying to find out the age of my engine so that i can start planning which bits i will need to buy. Its a CVH 1.8 with the following engine number:

RFFOEE-B7A

Using this chart:

http://www.burtonpower.com/technical...ate_chart.aspx

I think it is from 84, as there are no RF, FF, FO, or B7, or 7A's in the chart. Have i understood this correctly?

[Tatey]

Im afraid i dont have the engine number from the donor as i got it with the rest of my donor parts (i got a good deal on them all). After having a look on the net there only appear to be piston rings etc available for 1800 cvh engines from 88-94, meaning i must have the wrong number.

I'll got out and have another look.

Edit just been out for the past 5 mins having a look and i only managed to find 1 other number, which was really really faint, but it was just numbers, no letters, well atleast from what i can see. Is there any other way of telling what engine age it is?

[Tatey]

I found the first number on the head, and the second number on the top right of the block (side with the oil filter).

Where is the engine number located?

After having a look through the haynes manual for the sierra, the cvh 1800 R2A and R6A seem to use the same sized piston rings.

[HandyAndy]

if i remember correctly the engine number is on the block just below the carb inlet manifold ... or was it below the exhaust manifold?

i don,t think the main engine number is on the "head", its on the main block, which side i can,t remember,

you should have had a look at my engine earlier today

andy

[Tatey]

Just been out again and the number i thought were just numbers appears to be 2 'letters' followed by 5 numbers, i think its MD for the letters but it really isnt that clear as they are quite warn away, im pretty sure its an M at the beginning, meaning its from 91. Hopefully it'll come up a bit clearer once i start cleaning up the engine.

Im guessing it would be wise to re-stamp the engine number onto the engine in a clear and easy to find place?

[flyerncle]

Try a wre brush over it and then a pencil and paper to lift the number and if you want it restamped I have the stamps.
You know where I am.

[james3004]

I have got to restamp the engine number on my zetec, what size stamps do you have to use?

[HandyAndy]

Simon,
your engine is a CVH ( i remember lifting it )

i don,t think you have quoted the correct engine number as my CVH has similar markings to Adrian,s

whereabouts on the block did you find that number?

andy