Carbs

[mgglep]

Hi all I was going to run the standard sierra pinto setup until after iva but a have got very little room under the bonnet for an air filter I wondered how others got round this I would like motorbike carbs can these be ran without engine management
Thanks for any help

[alga]

I think it's well settled -- if you're running a standard downdraft carburettor, you have a hole in the bonnet for a chrome or foam filter. A way to avoid it is a set of sidedrafts, or bike carbs.

[MikeB]

i think you can use the same ignition set up you have for bike carbs but most will use megajolt or (I'm waiting for Nodiz from m-tech to come out next month).

[jps]

I'm planning to do motorbike carbs on a pinto too - potentially permanently. How do you go about getting a manifold made to suit the carbs?

[mgglep]

I have seen the manifold kits on eBay I think the kit is about 60 and the kit all welded up is about 130

[wylliezx9r]

Originally Posted by jps

I'm planning to do motorbike carbs on a pinto too - potentially permanently. How do you go about getting a manifold made to suit the carbs?

I believe "fastdan" on Locostbuilders does all that sort of thing. Think he has a website as well.

[TSM Locost]

Dan's website www.danstengineering.co.uk/

[deezee]

Originally Posted by jps

I'm planning to do motorbike carbs on a pinto too - potentially permanently. How do you go about getting a manifold made to suit the carbs?

I held the carbs in front of the engine, in around the right place I wanted them (bowls flat, good intake lengths). Propped them in place and took some measurements. Then I made a wooden jig, to which I fitted my manifold plate, I cut some tubes to suit. Took a whole day, but does the job.

[robo]

Stuff like this needs a top tip sticky. Another case of a picture says a thousand words

Bob