|
#1
|
|||
|
|||
Some questions about donor stripping
Evening...Started stripping my granada today ...reining myself in to rip it to bits without labelling everything...and photographing...the granada loom is huge ...electric everything....SO my first question is how do you vent the aircon system in a safe sort of way..and do you usually leave the aircon pump on the engine so the belt pattern is the same...2ND question if i undo the prop shaft bolts is it an easy lift out with engine with fron x member removed ??
|
#2
|
|||
|
|||
Quote:
rhys |
#3
|
|||
|
|||
Virtually all cars from the modern era the easist way to get all the bits out is to drop the whole subframe, suspension, engine and box down onto some dollies or even the floor, and lift the front of the car up and over.
It's how all that stuff went in at the factory If you've got some dollies then all you have to do is to lift the front of the car and pull the engine etc out. Best to leave the rear wheels on till this stage is complete |
#4
|
|||
|
|||
I have got my hands an engine hoist for free too !
|
#5
|
||||
|
||||
Easiest way to pull the motor from a Granny with an engine crane is cut out the front lower panel with a dangle grinder then pull the motor and gearbox out in one go with the hoist.
D.
__________________
visit my website at www.cossie.davenewell.co.uk |
#6
|
|||
|
|||
If I am having the front suspension out as well, easier still is use the crane to lower the whole lot onto the floor, then use the crane to lift the bodyshell up so the power unit/subframe/suspension can be pulled out from underneath.
If the suspension is not being removed, then that would not be the best way. |
Thread Tools | |
Display Modes | |
|
|