|
|
|
|
#1
1st February 2014, 05:50 PM
|
|||
|
|||
Rear up rights
Been checking my rear up-rights and when I place the shock end in between there approx. 8mm difference, firstly is this right and if so are people just using spacers to make up the difference.
Arfon 
|
|
#2
1st February 2014, 06:58 PM
|
|||
|
|||
|
If you mean the gap between the bush and bracket then yes,spacers,washers look kak
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#3
1st February 2014, 09:38 PM
|
|||
|
|||
|
I was thinking the same, I was also thinking of welding the spacer to each side of the upright and blending it to try and make it look one piece.
Arfon Last edited by TheArf : 2nd February 2014 at 12:03 PM.
|
|
#5
2nd February 2014, 11:00 PM
|
||||
|
||||
|
I used a stack of washers... They're a bitch to sting back onto the bolt after adjusting the camber... Thanks for the hint, I'll try to get some spacers made.
__________________
Albert Haynes Roadster FAQ | Haynes Builder Locations Gallery, build thread in Lithuanian / via Google Translate.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
