|
|
|
|
#1
9th December 2012, 04:46 PM
|
|||
|
|||
Pinto water Pump Hose.
Hi,
I've nearly finished put in all my silicone hoses except one. The small take-off from the water pump used to go to the heater matrix so i'm told. As i'm not using the heater and my weber inlet manifold dosen't have a water connection, so where do i connect the pipe to? Terry
__________________
If you need a friend, call me, if u need company call me, if you need help call me, if u need money this number is no longer available. 
|
|
#2
9th December 2012, 07:09 PM
|
||||
|
||||
|
Is this the one if so it went to the heater matrix then to the inlet manifold.
I'm guessing that you could blank it off as its no longer in use. DSCF2297 (Small).JPG
|
|
#3
9th December 2012, 07:16 PM
|
|||
|
|||
|
Thats the one.
Wasn't sure if i could blank it. As the water pump would be pumping water and it would have nowhere to go until the themostat opens, or have i got it ass about face. Terry
__________________
If you need a friend, call me, if u need company call me, if you need help call me, if u need money this number is no longer available.
|
|
#4
9th December 2012, 08:15 PM
|
||||
|
||||
|
I'm not too sure as I'm running the original carbs and manifold so I've just joined where the heater should be.
Maybe TT or someone else can give you a deffinite yes.
|
|
#5
9th December 2012, 09:12 PM
|
|||
|
|||
|
Thanks for your help Steve.
Think i've got it sorted now, found a very helpfull picture on locost. Terry
__________________
If you need a friend, call me, if u need company call me, if you need help call me, if u need money this number is no longer available.
|
|
#6
13th December 2012, 02:44 PM
|
|||
|
|||
|
Do you have a link to the above as I will need to re-route mine as I am fiting twin webbers and no heater
Arfon
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
