Bike Carbs

[Beardy_John]

Is anyone on here going the bike carb route? Thinking of giving it a go if I can do it on the cheap. My pinto manifold and carb just look pants.

(Hopefully, this won't get deleted! Someone must have found the button on their keyboard! )

[HandyAndy]

i,m hoping to go to bike carbs when i swap engines to a 2ltr zetec from what i have at the mo, 1.8cvh motor,
tho being honest i haven,t a clue what carbs i would need & the bits n bobs to go with them

but thats some way off yet for me

andy

[Coozer]

I have ZX9R carbs on my 2 litre zetec, also had them on the 1.8 before that.

Cheap as chips, carbs cost £35 and the manifold is homemade, whittled from some steel plate and tube.

[HandyAndy]

Originally Posted by Coozer

I have ZX9R carbs on my 2 litre zetec, also had them on the 1.8 before that.

Cheap as chips, carbs cost £35 and the manifold is homemade, whittled from some steel plate and tube.

cheezers Coozer, might have to ask for your help choosing some carbs/ manifold in the near future

i,m waiting to hear about those tyres for you, let you know as soon as i know.

cheers
andy

[DaddyA]

Hi,

I have the same problem with my CVH and carbs set up so I'm alo planning on bike carbs - not sure which yet but the feelers are out.

Also looking to use megajolt to replace that pile of wires they call hybrid. Anyone had any experience with that ignition system and know who sells it?

[mark]

Originally Posted by DaddyA

Hi,

I have the same problem with my CVH and carbs set up so I'm alo planning on bike carbs - not sure which yet but the feelers are out.

Also looking to use megajolt to replace that pile of wires they call hybrid. Anyone had any experience with that ignition system and know who sells it?

Im doing the same with zx6r carbs and megajolt. I using the original flange cut from the ford inlet manifold and welding some alloy tubes to it, but you need to blank off where the water outlet used to be in the centre of the flange.

The only problem is that the original water outlet comes out through the original inlet manifold and houses the thermostat on the edge of the manifold,the way round this is to pop out one of the core pugs on the end of the head and make a new thermostat housing to bolt to the tapped holes which are already in the head either side of the core plug

Then in future when i go 2lt zetec i will already have carbs, megajolt and exhuast on the correct side so should be a painless winter project