|
|
|
|
#1
19th August 2009, 01:58 PM
|
||||
|
||||
Seat strength members / extra support
Hi all,
It was posted a while back but cannot find it - possibly deleted?? Has anyone got the dimensions for the extra seat supports (hopefully some nice ones from Fabby) as I will be using ali for the floor and need the extra support for safety and of course the eventaul IVA. The ones between the sides and tunnel. What are people using - 40x3, 19x19, 25x25??? 
|
|
#2
19th August 2009, 07:44 PM
|
||||
|
||||
|
i gave andy all the dimensions for fitting fabbys seats a while back. If he has lost them then i will go out and re measure for you.
think i used 40 x 4 as its what i had, but even with the metro runners which are an inch high the seats are pretty low. im considering putting some spacers under them to make my seating position a bit higher.
|
|
#3
20th August 2009, 04:22 PM
|
||||
|
||||
|
Cheers Ash,
had a chat with Andy - would it be possible to get the measurements again??? Pretty please. Not too worried about being sat low - 6ft 2 with stumpy legs so body is about 5ft10, just need to make sure i'm below the roll bar. It will be easier to raise the seats if needed.
|
|
#4
23rd August 2009, 10:12 AM
|
||||
|
||||
|
Can anyone help with the spacing for the extra supports for the seats???
|
|
#6
23rd August 2009, 03:00 PM
|
||||
|
||||
Cheers Ash,
don't like to pester people, printed it off just in case!
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
