What threads are the maxi balljoints?

[aerosam]

I bought my maxi balljoints as part of a package from somebody on the anti Chris Gibbs forum and unfortunately I only received 1 nut. Now I have the car as a rolling chassis the bottom wishbone just falls out with no nut to hold it on.

So what is the thread, and does anyone possibly have a spare nut?

Thanks!

Sam

[aerosam]

surely somebody must know?

[Beardy_John]

I got mine from ebay, and they came with nuts. I'll measure them up tonight, unless someone beats me to it

[londonsean69]

Originally Posted by aerosam

I bought my maxi balljoints as part of a package from somebody on the anti Chris Gibbs forum and unfortunately I only received 1 nut. Now I have the car as a rolling chassis the bottom wishbone just falls out with no nut to hold it on.

So what is the thread, and does anyone possibly have a spare nut?

Thanks!

Sam

Surely you have a caliper or steel rule and a thread guage. Most Tap & Die kits come with a thread guage. Having said that, mine is metric only.

Or just very gently try a few nuts on it to see if one fits.

I have a sneaky suspicion it might be imperial

Sean

[Bonzo]

I believe they are 7/16" UNF

Had a quick look but have every possible Nyloc nut other than that one

[AshG]

from memory i think they are to corse to be 7/16 but i could be wrong.

[Bonzo]

Right this is the best I can do

I have two different brands of ball joint, One is made by Veco & the other is made by QH.

Both have the same thread.

I have just put my digital caliper on them. In metric the diameter of the treaded part is 11.9mm

Now here is the problem

Both the 20 TPI & 1.25 thread gauges fit the thread.

My Osborne cutting tool guide lists the following Two possible sizes.

M12 X 1.25 is a standard metric fine thread

7/16" X 20 TPI this is listed as a UNF thread size

Looking at my metric conversion chart, it is noted that the mertic range for 7/16" is 11.112 - 11.5mm

So given the outside diameter of the thread, it is probable that the thread is M12 X 1.25 ( Metric fine )

But I would not still rule out the 7/16" UNF in view of the possibility that this component could pre-date the metric era.

Please remember, This information taken from my tool guide & intended as a guide only



With a little luck, some of the more able engineers on the forum will have an exact answer.

[aerosam]

thanks guys.

An M12 nut will grip the first thread only then not screw down any further.

I can see me having to go and buy another balljoint just for the nut