|
|
|
|
#1
3rd December 2010, 08:50 PM
|
|||
|
|||
Rear shafts/hub's
Anybody shed some light on the following question.
Are the rear bearing carriers the same for push in and bolt on driveshafts and are the splined drive flanges the same. Cheers.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice. 
|
|
#2
3rd December 2010, 09:40 PM
|
||||
|
||||
|
It's possible to fit Lorobo bolt on outputs to the diff & Vice Versa from what I understand.
The bearing carriers are different between disk and drum. 99.9999% of drum braked cars had push in shafts. and as far as I am aware 100% of disk cars have bolt on shafts. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#3
4th December 2010, 07:42 AM
|
|||
|
|||
|
We fitted Lobro stubs to a push fit diff and had issues with the left hand stub locking the planet gear shaft.
The solution was to grind off a mil or 2 from the stub end, this makes the circlip groove a little close to the edge. Either the push fit outer bearings sit a couple of mil further in the casing or the planet gear shaft is a little bigger in diameter. It's not a drama but does need carefully looking at if you do this mod.
|
|
#4
4th December 2010, 09:04 AM
|
|||
|
|||
|
Thanks gents,next question is it possible to fit push in shafts/drive hubs to disc bearing carriers or do I modify drum carriers with a bracket to mount the caliper.
Cheers.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
|
#5
4th December 2010, 09:16 AM
|
||||
|
||||
|
You buy the brackets from 3GE.
TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders
|
|
#6
4th December 2010, 09:24 AM
|
|||
|
|||
|
Probably easier, cheers.
__________________
Cost : Little as possible. Thanks : To those who by their generosity my build has progressed. Its a handmade sports car not a flaming kit car !!! If at first you dont succeed,avoid skydiving... No parachute require to freefall,only if you want to do it twice.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
