which clutch????

[whitstella]

hi

i've got a type 9 gearbox with bell housing, but i seem to be short of the clutch arm. does this come with a complete clutch kit or have i got to find 1 seperate????? the engine i will be using is a 2l zetec with hopefullt a 1.8l fly wheel. what clutch kit do i need and release bearing???

cheers steve

[jasongray5]

On my 1.8Zetec im using a standard mondeo clutch kit, but longer release bearing. Will try and find you the part number

[jasongray5]

Part No. CCT113. Its from a capri so that should help your search! Good luck!

[baz-r]

is it heavy at the pedal with this pressure plate?
i will be using a 1800 silvertop on a type9 and will be getting to this bit at some point

[jasongray5]

I dont find it too bad? Although if you did, then you could always move the cable down the pedal? if you see what I mean?

[alga]

On a 1.8 flywheel, you need Mondeo 1.8 clutch (220 mm disk, 26mm shaft, 23 splines). As for the clutch release bearing, some people make do with a Sierra bearing (Quinton Hazell CCT132), also I've heard some put on two of those, some get the longer CCT133 bearing. Here's a list of part numbers of equivalents in other catalogs: http://www.haynes.co.uk/forums/showt...?t=4036&page=3