SS1 and CP11 and GRP Rear Tub

[Ashtonr]

Ok another quick sanity check, Im trying to align the Rear Tub made from GRP
and it wants to interfear with the SS1 infils, am I right in assuming if you fit a GRP rear tub the SS1 and CP11 bits are not needed ?

[trick-kit]

That's right, if fitting the rear tub, the radius that forms that area wants to end in the corner of the chassis.

Hope that makes sense

ATB

TK

[Ashtonr]

Thanks for this, I will cut them off then

[Ashtonr]

Fits perfectly with these removed

Many Thanks

[Ashtonr]

Has anyone got any drawings showing what to remove for the rear suspension / upright etc from the rear tub in relation to SB1 and D11 ?

[HandyAndy]

Originally Posted by Ashtonr

Has anyone got any drawings showing what to remove for the rear suspension / upright etc from the rear tub in relation to SB1 and D11 ?

Do you mean what you need to cut out of the rear tub GRP panel so that you can then refit the suspension/upright/wishbones?

if so, then fit the tub without any rear suspension on the chassis, cut out the GRP following the rear face of the SB1,s & the forward face of the D11,s, don,t go too high up to the suspension "box", ( approx 2 inches below the bottom edge would be about right ),

I,ll have a dig around & see if I can post up a photo of how mine was done.

cheers
andy