Rosco's haynes Build

[Rosco]

Rear seat panel



Tunnel sides

[Rosco]

Made a few modifications to my bead roller, welded a handle on to apply the roller pressure and swapped the bottom wheel for a plastic one as the metal one was a bit heavy on the aluminium



Engine hatch marked out



Finished panel, I was a bit worried about ruining it, but it's turned out perfect, tomorrow night I'm doing the big floor panel

[Rosco]

Got my floor beaded tonight with the help of my dad, could of done with another set of hands really as it's quite a big sheet

Turned out quite well, one bits a little dodgy but I will give it a little tap before I rivet it on





What it looks like from the inside

[vmax1974]

Looking good as usual loving the rollers any chance you put us a set of drawings together for the roller

[Davidbolam]

Really nice build there. I have been following all of your thread. I like the enclosed bottom. The only question I have is where will all the hot air go from the radiator etc? Are you going to vent the sides of the body?

[Rosco]

Originally Posted by vmax1974

Looking good as usual loving the rollers any chance you put us a set of drawings together for the roller

I could do pal, if I was to make it again I would do it a bit different tho

[Rosco]

Originally Posted by Davidbolam

Really nice build there. I have been following all of your thread. I like the enclosed bottom. The only question I have is where will all the hot air go from the radiator etc? Are you going to vent the sides of the body?

Urm, I'm not really sure to be honest, not really thought about it,

Could it go down the tunnel and out of the boot floor, above a diffuser? Or yeah I could vent the rear of the side panels and the bonnet

[Rosco]

Dropped my chassis and everything off at the powder coaters yesterday morning and collected it this morning, well happy with it! I feel like the ends now in site!

[Rosco]

[NeilW]

Looks awesome mate, the pedal box is really nice. When you taking orders??