DIY Inlet Manifold - Haynes Forums

		Haynes Forums > Haynes Roadster Forums > Engine/transmission
DIY Inlet Manifold

Thread Tools

Display Modes

30th August 2009, 06:28 PM

Jimmyd

Senior Member

Join Date: Jul 2008

Location: Portaferry, Co Down

Posts: 246

The plan is to weld a circular mouth to the existing branches and then create a smooth internal flow to reduce the turbulance. By that stage the carb should be sitting very close to the new mouth with very little rubber between so I don't think it'll be a problem.

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 11:10 AM.