|
|
#3
6th October 2009, 11:22 PM
|
|||
|
|||
hi again
ive made the jig for the front lower wishbones as to book specs i cut the 25mm seamless to lenth placed them on the plate put the tubes on the end mitred them measured them to lenth end to end and now the holes on the plate dont line up with the holes in my jig to bolt the plate down i cant see what ive done wrong :s any ideas? thanks Andy Last edited by andyuk697 : 29th October 2009 at 05:05 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode