|
|
#4
31st October 2009, 09:34 PM
|
||||
|
||||
The very best of luck to you there fella if your going down that route, it's hard enough to make the chassis straight and square if you can weld to a reasonable standard with a MIG let alone MMA. If it's the cost of the welder your thinking about you might be better off with a scratch start 160 amp TIG set.
__________________
Website http://www.talonmotorfabrication.co.uk/ Direct email phil@talonmotorfabrication.co.uk talonmotorfabrication@gmail.com Mobile office hours 07514098334 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode