|
|
#19
10th January 2010, 07:53 PM
|
||||
|
||||
That still does not answer the question though. Is the taper of the axminster reamer the correct angle to match the ball joint taper?
The taper on the joint should be paralel to the taper in the hole otherwise there will be a loose fit at one end or the other. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode