Front lower wishbone jig

		Haynes Forums > Haynes Roadster Forums > Chassis
Front lower wishbone jig

Thread Tools

Display Modes

21st April 2010, 08:32 PM

filip arvidsson filip arvidsson is offline

Junior Member

Join Date: Mar 2010

Posts: 19

Front lower wishbone jig

Hi!
Is the height(18,5 , 10) of the platesupport correct? The plate will be a couple mm lower then the middle of the tubes.

Should the piece of plate that goes inside the tube be bent too?

Want to make sure before welding

Thank you
//Filip Arvidsson

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 04:57 AM.