|
|
#4
1st July 2010, 07:10 PM
|
||||
|
||||
Yes, I've got about 15mm between the mount and the column now. If you use the book positionfor the bearing position I found it to be too low as i think the cutouts in the 1mm plate should be 25mm and not 10mm (sorry not got the book to hand) By using the bearing you can get the column a bit higher, I plan to fill the old bearing hole with a bit of rubber sheet riveted over it. Hope that is some help.
__________________
Gallery 2 http://www.facebook.com/album.php?ai...4&l=a9831a9319 Gallery 3 http://www.facebook.com/album.php?ai...4&l=3f0d42c523 Gallery 4 http://www.facebook.com/album.php?ai...4&l=efb083b7df Gallery 5 http://www.facebook.com/media/set/?set=a.10150244028550325.366987.601005324&l=583fd5 cd3a Gallery 6 http://www.facebook.com/media/set/?set=a.10150550640070325.430417.601005324&type=1&l =fe779b358c Last edited by davidimurray : 1st July 2010 at 07:26 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode