|
|
#10
25th August 2010, 12:29 PM
|
||||
|
||||
Sorry but you need to start off with a good square and flat chassis otherwise you're going to come across loads of problems later on and 36mm is an awful lot. If its only tacked then i would check your build table is marked out correct, HAndy may have some spare templates left, and remake it. Or you could bring it over to the North East and i'm sure me and HAndy could remedy the problem and jig on the suspension brackets so that you have a good base to start from.
All the Best....AndyH
__________________
Haynes Roadster / Saturn GRP Bodywork. Now available direct through http://www.gillhamonline.co.uk/ or contact me direct on andrew.hugill@ntlworld.com Regards..........AndyH 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode