Went to machine mart, bought impact gun, no joy. Put a bar accross the studs and got all three neighbours to stand on the subframe while i forced on a 12ft piece of scaffolding pipe attached to the wrench and all i did was lift everyone off the ground. I really dont know what to try next.
David, you said that i dont need to remove the hub nuts? dont i need to remove the hub to get the driveshafts into the rear hub carriers? Either way i would like to remove them just to put new bearings in.
Does anyone have any further suggestions? im getting pretty tempted to start the grinder up or try and find an industrial nut splitter.....
Cheers
nathan
|
21st September 2010, 07:15 PM
Threaded Mode