Hello but I'm not building a Haynes roadster, quite

[Davey]

Well work has gone quiet at the moment (slightly worryingly so ) so I've been doing a bit to the Dragon. Over the last few days I've framed up the rear end, I'm going for ali sheet over steel tube frame. The bottom rails I've made out of 25mm sq 3.25mm wall the same as the rest of my chassis but I've used a piece of 19mmdia round tube for the top rail. I nipped round to a local electrical contractor yesterday to see if they could make the bends for me with a conduit bender, they did and I had a nice little chat with the boss while his mate bent my tube. Turns out the gaffer is a petrolhead who runs a 7 litre V8 Corvette, he showed me a pair of tyres he has on the shelf ready for it (cripes they're wide) and reckoned they'll be the third set on it and its only done just shy of 7K miles so far . Anyway they did a smashing job of bending my tube and the only charge was a promise to take gaffer for a blast when its done .

I've been working on the pedal box too but today I tried it all for size with the drivers seat in place only to discover a major cock up, the top of my scuttle is about four and a half inches to low . This is the trouble with not doing my build by the book I suppose. Not a major headache to sort out, probably about two to three hours work I reckon but it does come with some good news. I am planning a top hinged pedal set with the brake master cylinder in front of the scuttle, as it was the brake reservoir would sit about two inches above the scuttle top. Once the scuttle top is raised the master cyl reservoir will be about an inch and a half below the scuttle top. The bonnet line will also be better for covering that mother of a motor.

I do have some photos but they're on my phone and I've left the data lead at work so I'll have to post them tomorrow.

D.