|
|
#1
16th February 2011, 10:38 PM
|
||||
|
||||
Roll bar IVA
Is there any particular spec for iva about the angle of the rear stays on the roll bar? Mine are going to be quite a steep angle, due to the location of fuel tank, pump and filter.
Also does each side need 1 bolt or 2? Ive read both answers when searching, in theory i'd like 2 to be safe, but space is tight. Hope someone can shed some light. Cheers Dave.
__________________
~ My Build Diary - http://davesroadster.blogspot.com/ *updated 7/6/11* Best bit so far: Getting it running Worst bit so far: Cutting steel for wishbones and engine mounts. Most annoying bit so far: Generator packing up half way through welding. Last edited by David_17 : 16th February 2011 at 10:41 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode