Saturn MX5 Front Upper Wishbones

[andysredmini]

Hi Andy
Thanks for your reply.
I hadn't noticed anything was wrong with the drawings!
I drew my plans by first drawing the jig and positioning the bushing tubes and 30mm round bar on the jig. then sketched between them and added the tube to the sketch.
I'm looking forward to the new revision so I can get off the computer and actually build the wishbones.

I worked out earlier how to get Autodesk Inventor to produce a paper template to print out and wrap around the tube to mark the fish-mouths for tubes. I did a test piece earlier on some scrap tube and it worked perfectly.
Ill upload them to my blog when the dimensions are finalised in the build guide revision.

Thanks for your hard work on the guide. It really is appreciated

Andy