Chris's new build of an MX5 based car

[CTWV50]

So the second engine mount is done, very pleased with it too.



Got the front end on too....



went together really well, yet to add the rack and I got it off the table.



Forgot to take a picture before putting everything away but this will do for now.



Hip Hip Horay!!!!

BUT!

I did hit a bit of a problem. I'm not sure how much of a pain it will be to fix but basically I could only fit the rear pass side hub to the wishbones by putting about 10˚ of camber into it. Seems the driveshaft (halfshaft) is pushing the the hub too far out. also noticed that when lifting the hub it was stopped from travelling up by the driveshaft which then bounced the other hub up so something is not right. Seems I may need to think about moving the diff slightly. Took loads of measurements to see where I went wrong but can't real account for this issue using measurements alone!