danST Engineering

[FASTdan]

Hi All,

Some of you may know us from the locost builders forum among others. Just a quick post to make everyone aware of what we can offer:

Bike carb and throttle body manifolds. Fully TIG Welded aluminium construction built to suit whatever carbs/bodies you source. We also build these into complete packages consisting of carbs, manifold and fluoro lined fuel resistant silicone hoses (in a choice of colours).


Self weld Mild Steel Manifold kits. Again to suit whatever carbs you source. These kits consist of 8 tube sections cut and marked ready to weld to give your required engine/carb spacings and the 8mm flange plate to suit.

Pipercross PX500 and 600 Filter baseplates. Either blank or cut to suit a variety of bike carb applications. We also stock the filters.

Velocity stack kits to suit the popular bike throttle bodies.


A wide range of laser and water jet steel, aluminium and stainless steel manifold plates to suit most popular ford engines aswell as other manufacturers.

We also stock the popular DCOE/Jenvey type plates in 10mm aluminium.

Duratec Engine Mount kits designed to suit the MK Indy/Book Chassis.

Prop Shaft Catch Plates. Designed to mount in the tunnel of your Locost to capture the prop in the event of a failure.

The above is not exhaustive, other products and information can be seen on via the following links:

www.danstengineering.co.uk

http://stores.ebay.co.uk/DANST-Engineering

http://www.facebook.com/pages/Danst-...8944900?ref=ts

Any questions please email enquiries@danstengineering.co.uk.

*Edited to remove pics as they were far too big, please see above links.*

Thanks for looking.

Regards

Dan
danST Engineering