Column bearing

[robo]

Originally Posted by DRCorsa

I have this bearing: SLFL25 LDK Pressed Steel Flange Bearing



I will use it to mount my column shaft to the bulkhead. I know than many people have used it but i am looking for pictures to see how exactly you have mounted it. If i mount it on the CP16 plate, i will have to open a large hole (56mm diameter) which is not the easiest job to do, unless i order again the CP16 from the laser shop.

Any ideas?

I think the pressed steel bearing looks a bit less agricultural than the cast one Either way its better than the poxy sierra one.

Bob