Sierra cast alu engine mounts

10th May 2013, 10:10 PM

jps

Senior Member

Join Date: May 2012

Location: Colchester, Essex

Posts: 439

I'm also going to use some 40mm box section which is 4mm wall I think. not sure if your box section is thick enough, also it's not welded all round, can you not construct it in such a way that you weld around the whole end of the box section rather than just one side?

__________________
http://meandthekitcar.wordpress.com/

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 11:09 AM.