#1
|
|||
|
|||
1 piece floor vs 2 piece floor
I posted over on Locostbuilders just to see what kind of advice I would get as to the process to follow when riveting/bonding an alu floor panel onto my chassis. (whether to rivet in a certain pattern/etc)...
Interestingly I got feedback from some respondents to say - don't use a 1 piece floor panel: "Having the tunnel panelled just means it fills with cr@p from the road and there's reduced route for engine heat to exit. Keep it simple and lighter, and just panel in each person's half. " "I wouldnt worry about the tunnel either i had a Tiger with propshaft and i wouldnt have wanted the floor in the way for if i needed to check/work on it." "My advice to this chappie (as another has said) is the *keep a separate tunnel floor section*. This can then be removed for prop inspections, etc., as well as getting the rubbish out. " What do actual Haynes builders have to say about this though?
__________________
http://meandthekitcar.wordpress.com/ Last edited by jps : 18th August 2014 at 12:19 PM. |
Thread Tools | |
Display Modes | |
|
|