![]() |
#241
|
|||
|
|||
![]() |
#242
|
|||
|
|||
![]() Wishbones fitted
![]() Few other bits fitted ![]() Today's job was to get the seat panel fitted, my dad gave me a hand as it was quite tight and didn't want to scratch everything The panel fit really well from the laser cutters and only needed a little trim on the tunnel top, then the top and bottom needed bending We clamped the bottom Inbetween two bits of box section and the top between timber with a bevel on the back ![]() It folded real nice We both decided it needed bead rolling to match the rest ![]() |
#243
|
|||
|
|||
![]() |
#244
|
|||
|
|||
![]() |
#245
|
|||
|
|||
![]() Engines back in to with stronger clutch springs
![]() Gear linkage next, just working out the size of the bell crank to be made ![]() Down arm added to gear lever, this will be shortened once I've decided the holes in the right place ![]() Lastly put some skateboard grip tape on my pedals, also a clue as to what sort of colour scheme I'm going with ![]() |
#246
|
|||
|
|||
![]() Jealousy is flowing freely through my veins!
How did you drill the bottom row of rivet holes in the rear panel without the floor getting in the way? |
#247
|
|||
|
|||
![]() Quote:
Haha thanks! Urm I dunno really, I just angled the drill away a little, it was close but it's quite a slim chuck on my drill |
#248
|
|||
|
|||
![]() |
#249
|
|||
|
|||
![]() Ah good, I thought I was over complicating it in my mind.
|
#250
|
|||
|
|||
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|