![]() |
#1
|
||||
|
||||
![]() *excluding actual important events
Finally managed to get my dad to sweat it out in his workshop machining all 44 bushes down to suit the incorrect diameter end tubes I purchased ![]() ![]() Well as it turns out, I could do what This Thread warned about and fit my rear suspension as per a 3D drawing I had in AutoCAD. The result, 8 fully welded wishbone brackets in the wrong place. I did all this around a month ago, all the spacings were correct..... you know.... just in the wrong place ![]() So after putting a slitting disc into my hand being dumb with frustration I'm struggling to remove these brackets. Anyone got any useful, practical advice. I the absence of useful advice, I'll accept; Read the fricking Book, Measure twice, Weld once and also DURRRRRRRR. |
#2
|
|||
|
|||
![]() Unlucky mate, I wouldn't be so judgemental as to say "read the book" but....er...you know
![]() Buy some thicker gloves too! Cheers Chris ![]() |
#3
|
||||
|
||||
![]() if it makes you feel a little better....
even tho i posted within the thread advising of this in the link that you gave i,ll be honest & admit i STILL put 2 brackets in the wrong place ![]() andy |
#4
|
||||
|
||||
![]() well done for keeping at it. i think i would have had to go have a little sit down for a few days to calm down.
|
#5
|
||||
|
||||
![]() Quote:
![]() ![]() |
#6
|
||||
|
||||
![]() What a Bummer.
![]() ![]() PM sent to you ![]()
__________________
I am not a complete idiot...........Some of the parts are missing !! Ronnie ![]() www.roadster-builders.co.uk |
![]() |
Thread Tools | |
Display Modes | |
|
|