|
|
#1
30th September 2009, 01:07 PM
|
||||
|
||||
Rack issues :-S
Got my rack from rally designs this morning, so went for a trial fit. Problem, my sierra column is too big to fit over the splined input of the rack?
My sierra had a Power assisted rack if that makes any difference? Is that the cause or is it something else do we think? Cheers Guys Jas
__________________
http://www.flickr.com/photos/3326151...7611049241239/ 
|
|
#2
30th September 2009, 01:34 PM
|
|||
|
|||
|
It must be because yours was a power steering model as i have a rally design rack too and my doner parts fit fine.
Im sure somebody will be along shortly with a combination of what couplings etc you need to make it fit! I would imagine that the column will be the same but the linkage is obviously different so maybe try and get one of those from a non power sterring model. thanks
|
|
#3
30th September 2009, 02:09 PM
|
||||
|
||||
|
Cheers Mark.
Next question, does anyone have one spare that I could exchange for beer tokens? Jas Gray
__________________
http://www.flickr.com/photos/3326151...7611049241239/
|
|
#4
30th September 2009, 02:37 PM
|
||||
|
||||
|
Jas if you can get hold of a group4 coupling to fit onto the rack spline then i can send you the stainless steel shaft that fits into the coupling then you weld that to your steering column extension.
no beer tokens needed  andy
|
|
#5
30th September 2009, 02:49 PM
|
||||
|
||||
|
Cheers bud! Will have a scratch around and see what I can see!
Jas
__________________
http://www.flickr.com/photos/3326151...7611049241239/
|
|
#6
30th September 2009, 02:55 PM
|
||||
|
||||
|
no prob, the splined shaft i have spare is half of what i bought from rally design, you can get the couplings from them too, just ask for mkII escort rack group4 coupling, can,t remember for sure but think they are approx £12.
andy
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
