bonnet dimension

[fabrun]

hello everyone
can someone give me this dimensions (can you tell where you buy your kit)
thanks

and merry christmas

[LeonN]

Someone will come along with the dimencions you require I am shore.
The BMW engions are quite tall so I am resurving judgment on scuttle, nose and bonet hight untill engion is in.
Mabey we will need to redesign the intake manifold so it does not sit ontop of the rockercover to make it fit.

Do you intend modaling the engion?

[alga]

The rear of the bonnet is 230 mm above the rails, see page 94.

[flyerncle]

Depends on scuttle and nose cone used as the heights will vary if they are placed direct to chassis and not on original design for metal scuttle.

[fabrun]

thanks
i will modeling the engine( roughly just for volume and hole fixation ), don't know when!

missing the front and the length

[LeonN]

Cool I will be exited to see a BMW block in cad. Even if it is not realy detaled.

Good work.

[Chris_]

Running ITB's will lower the height significantly. As it gets rid of the inlet manifold sitting on top of the engine.

Out of interest what engine are you using?

Chris

[fabrun]

bmw 316i 1.6 e36 compact m43