Front Camber Adjust Nut

[Enoch]

Hi there, what have you guys done re covering the front camber adjust nut for the IVA test? I can't find anything that I think the inspector will be happy with
Any ideas welcome.
Enoch

[Qwerty9]

Enoch,
What about these,

http://www.saturnsportscars.co.uk/st...d&productId=67

Cheers,
Andrew

[spud69]

Some large diameter cable heat shrink should do fine Dave

[spud69]

Originally Posted by Qwerty9

Enoch,
What about these,

http://www.saturnsportscars.co.uk/st...d&productId=67

Cheers,
Andrew

We posted at the same time Andrew, you still need the lock nut on the outside to use the adjusters though. Heat shrink worked fine for me and others i know that have gone through. Something like this:

http://www.audiospares.com/product.p...2&cat=0&page=1

AndyH

[Enoch]

Thanks Spud, I thought Ash found out that heatshrink was not permitted any more?
I am thinking of speaking to my local test station and asking a few direct questions to try and elliminate some of the variances.
Thanks again,
Enoch

[spud69]

I think Ash just had a very pedantic tester, as far as i'm aware heat shrink is fine but if you're not sure cable glands can be used just need to get the correct size.

AndyH

[Enoch]

Thanks again Andy. I think I will try to speak to the IVA centre and see if they are equally pedantic when the build is not being covered by a national magazine
Best and all that.
Enoch

[Qwerty9]

Spud69
Jumped in without reading properly, have since read and realised my mistake.

Cheers