#11
|
||||
|
||||
Quote:
|
#12
|
||||
|
||||
Hi, the plenum is the big ally air intake that has the throttle body attached to it at the front you seem to have removed it from the engine already.
unless your car is a carbed version in which case you dont need to worry about it Ray ps i did post a pic of a modded one on here ages ago so it is possible if you are dead set on using the engine but you will have hassle |
#13
|
||||
|
||||
It's defiantly lighter.
Quote:
More power than any CVH other than an RST More power than Most 1.8 Zetecs. Quote:
Quote:
Quote:
Every engine fitment is going to take a bit of work. I see no reason not to use the DOHC even though If I am honest I hate the bloomin things. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#14
|
||||
|
||||
I didnt know an engine could show defiance lol
definately a very naughty one indeed bad bad engine dont do it again lol |
#15
|
||||
|
||||
Quote:
Joking aside, I hate the DOHC.. I have had a few of them and they usually use water as a consumable.. But they produce good clean smooth power and are tractable. TT
__________________
You only get a woosh with a dump valve Build Thread Man Cave Mantiques Cecil Street Auto Repairs Garage Carlisle Build Cost £4181.65 - Last - Wheel Cylinders |
#16
|
||||
|
||||
Did you hear about the dyslexic pimp
bought a warehouse lol dyslexia rules no k etc |
#17
|
||||
|
||||
Raylee29,
It's DOHC with carb PS Why is Dyslexia so hard to spell? |
#18
|
||||
|
||||
That will make it easier as you may be able to use the inlet untouched, you will still need to mod the sump and possibly remove some of the bottom of the bellhousing also give some thought to getting the flywheel lightened as it wheighs loads
Ray even harder to spell dispraxia lol |
Thread Tools | |
Display Modes | |
|
|